Quality Rule Sets

Creating Set

To create a set of rules:

1. Make sure that draft mode is enabled and a draft is selected.

2. Make sure that the Set of rules tab is active in the “Data Quality” section.

3. Click “Create set” on the right side of the table header.

4. The action will open a drawer with the settings for the new rule.

5. Fill in the basic settings:

   • Name. Logical name of the set.

   • Display name. Name that will be displayed to users.

   • Description (optional). Additional information about the set.

6. Specify the structure of the quality rules in the set.

   • Rule. Dropdown list with quality rules.

   • Context. The execution context for the selected rule. Upath expressions are used which allow to select collections of attributes for function ports using additional criteria. The selection of complex attributes and the selection of one attribute from a complex attribute are available. Any nesting level is possible.

   • Incoming. Incoming ports of the quality rule.

   • Outgoing. Outgoing ports of the quality rule.

7. If necessary, add one or more quality rules to the set. Click the “Add” button located on the right side of the settings header.

8. To change the order of the quality rules, use the up and down arrows. The rule that is at the top will be run first. For convenience, the areas with quality rules can be collapsed by clicking on the header.

9. If necessary, remove the quality rule from the set. Click the “Delete” button located on the right side of the settings of each rule.

10. Save the changes. Click the “Save” button located in the upper right corner of the drawer.

11. To continue, go to the Assignments tab to assign quality rules.

After all the data has been entered and saved, publish the draft.

Figure 1. List of sets

Figure 2. Properties of a new set

Editing Set

Editing is available for each tab in the “Quality Rules” section.

To edit a set:

1. Go to the Set of Rules tab.

2. Select the required line in the list:

   • This will open a drawer. Some fields, such as the logical name, will be unavailable for editing.

   • Make changes.

   • Save the changes. Click the “Save” button located in the upper right corner of the drawer.

3. After all the data has been entered and saved, publish the draft.

Deleting Set

Deletion is available for each tab in the “Quality Rules” section.

In the “Set of rules” tab:

1. In the list of rules, select the required rules with a checkbox.

2. The “Create set” button will change to the “Delete” button. Click this button.

3. Confirm the action.

4. After all the data has been entered and saved, publish the draft.